KFX450r Velocity Intake System

NOTICE: the KFX factory intake snorkel is a tight restriction

robbing your KFX450r of bottom end throttle response/torque

and high RPM power.  

Remove that restriction and bolt-on a lightweight Velocity Intake System!! 

Replaces factory airbox with a mandrel bent and ultra-light aluminum intake tube. 2 in. to 2 1/2 in. Velocity Stack reducer at throttle body. Intended for use primarily in dry riding conditions K&N filter included!

Comes with K&N RU-0640 with water repellent Outerwears 20-1090-01

Increases intake velocity for max power at high RPM's with a noticeable increase in bottom end torque. Why? The stock intake snorkel has a tight bend that is restricting airflow. At low RPM the stock intake snorkel is holding back a punch when you jump on the throttle.  This increase in throttle response you will notice immediately!         

You will feel the power increase in top-end power when you completely un-restrict your R450's throttle body. The Velocity Intake will allow you to make maximum HP enhancing any additional modifications.

This intake is intended only for dry to moderately wet riding conditions, and is perfect for TT/moto's/drag racing/absolute dune ripping. Shaves off 3.8 lbs. from stock aribox this intake with filter and hardware is only 1.4 lbs vs. stock 5.2 lbs.

Intake tube starts with a mandrel bent 6061 T6 aluminum tubing; a welded bracket bolts to the left airbox mounting pad. A provision on that bracket mounts the air inlet temp sensor (attached to the intake snorkel in stock form). Polished finish can be hand rubbed to a mirror shine.

KFX450r Velocity Intake Features

Aluminum Intake (3.8 lbs lighter than stock airbox)

K&N High Performance air filter

Outerwears water repellent Pre-Filter

Heavy Silicon Velocity Stack intake reducer

Hardware and all mounting provisions

Polished finish

Optionally available as an Intake Only kit with no Filter or Outerwears

Check out a Recommended K&N Crankcase breather,

$18 + Free shipping with intake purchase!